Menu   ()   ()
  Cart ()     Wishlist ()
hydronic banner hydronic heating

HYDRONIC 
HEATING

Hydronic Heating simply uses hot water to heat instead of conventional blown hot air; water being far more efficient method of carrying heat. Similar to the way the sun heats our planet, hydronic heating provides a more even, natural radiant heat throughout the house.

BENEFITS

hydronic benefit health

HEALTH

Ensure a safe and healthy environment for you and your family with underfloor heating.

hydronic benefit design

DESIGN FREEDOM

No radiator panels on the walls or ducts in the ceiling and floor.

hydronic benefit efficiency

EFFICIENCY

Using energy efficient gas boilers gives you greater efficiency and return on cost.

hydronic benefit comfort

COMFORT

Underfloor heating provides you with the ultimate heating solution.

HYDRONIC VS DUCTED

hydronic vs radiant

RADIANT FLOOR HEATING

Without a constant even spread of heat, rooms are left susceptible to draughts and cold spots. The underfloor system provides a constant natural even distribution of radiant heat, ensuring the ultimate comfort for your home.
hydronic vs forced

FORCED AIR HEATING

Because heat rises, underfloor heating is one of the most efficient ways to heat your home. Traditional air heating methods rely on forcing warm air throughout the house resulting in an uneven distribution and heat retention. This is particularly challenging for dwellings with high ceilings.
hydronic system radiant

RADIANT UNDERFLOORHEATING SYSTEM

Our comprehensive system has all the components required to perform an underfloor heating installation, including Auspex Radiant pipe and Auspex crimp fittings, manifolds and control valves, and time-saving Smart Clips for fixing the pipe to reinforcing mesh.

read more

SIME Conventional Condensing and Combi boilers

Sime has a range of Conventional, Condensing and Combi boiler which all deliver natural heat through the home with underfloor heating, radiator panels or towel rails. The combi boiler also combines central heating and hot water in the one appliance.

Read More

hydronic system sime

FAQS

Q1. Can underfloor heating be installed on sand?

Yes, installation of underfloor heating can be done in exactly the same way on the reinforcing mesh when building on sand. It is recommended for better efficiency of the system to use a layer of insulation between the sand and the slab.

Q2. Is an underfloor heating system more efficient than ducted air?

Yes. Because it uses the entire slab as a heating surface, and creates the heat where it is needed - around the body and not the head - the system can be run at a lower temperature and requires less energy to run, saving up to 20% on gas bills.

Q3. Do I need a qualification to install an underfloor heating system?

Auspex Radiant and REHAU provide all the training required to be able to install the underfloor heating system, and with completion of all the training modules you can receive a full certification as an Hydronic Heating underfloor heating installer.

Q4. Do I need to purchase any additional items outside of the kit to complete my installation?

The Smart Clip tool and supply line pipe (to connect the boiler to the manifold) are sold separately to allow for variability in your installation requirements. Everything else you need is included in the kit.

Q5.  Do Auspex Radiant and REHAU offer design and technical support? 

Yes, a full design service is available to provide a complete plan of piping runs, and specification for the system settings, and their teams are available to provide further support on site.

Q6. How long does it take to install an underfloor heating system?

As an approximate guide, it takes about a day for the initial install of a system in a standard home before the concrete pour, then about half a day for final commissioning of the system.